How to engrave on brass with a fiber laser
Fiber Laser Engraving Parameters for engraving on Brass.
These are the best settings for engraving over Brass with a fiber laser engraving machine BCF, Raycus, JPT or others.
Speed
1500
Power
90%
Frequency
60
HATCH : 1
HATCH type: Bidirectional
ANGLE: 90
LINE SPACE: 0.05
Note: These engraving parameters are for reference, and the results may change deepening on the lens, power laser source brand, metal mixture, ETC.
We have tried with
These parameters have been tried with a fiber laser BCF 30W with a 10x10cm Opex lens. Also, These parameters can be applied to Raycus and JPT.
Software used
We have used EZcad 2. But these parameters also apply to EZcad 3 and, in general, any laser control card from JCZ.
Variations
Speed, frequency, hatch, and line space, can remain the same, but you may change the power percent if you own a laser with more power or less power.
All this information does not represent the engraving time. The time varies depending on the design or pattern to engrave.
