How to cut Aluminum with a fiber laser
Fiber Laser Engraving Parameters for cutting Aluminum.
These are the best settings for Aluminum cutting with a fiber laser engraving machine BCF, Raycus, JPT or others.
Speed
120
Power
90%
Frequency
35
HATCH: Bidirectional
HATCH angle: 0
LINE SPACE: 0.5
WOBBLE DIAMETER: 0.35
WOBBLE DISTANCE: 0.1
Set up CONTINUOUS engraving MODE. or set up 65 LOOPS or more.
Note: These engraving parameters are for reference, and the results may change deepening on the lens, power laser source brand, metal mixture, ETC.
These parameters in our BCF 30W can cut up to 0.3MM Aluminum, taking considerable time.
We have try with
These parameters have been tried with a fiber laser BCF 30W with a 10x10cm Opex lens. Also, These parameters can be applied to Raycus and JPT.
Software used
We have used EZcad 2. But these parameters also apply to EZcad 3 and, in general, any laser control card from JCZ.
Note:
Remember to set up the WOBBLE for cutting material with EZcad software. We use the same WOOBLE settings that we use to cut other materials for gold.
Go to option ADVANCE and set up.
WOBBLE DIAMETER: 0.30
WOBBLE DISTANCE: 0.1
Variations
Speed and frequency can remain the same, but if you own a 20W, 50W, or 100W laser from us or from other brands, you can cut relatively faster and deeper.
50W up to 0.3 to 0.7mm.
100W up to 0.5 to 1mm.
All this information does not represent the cutting time. The time varies depending on the design or pattern to cut.
Also, you may try to cut thicker materials on your own.
