How to engrave Black color on Aluminum with a MOPA fiber laser
MOPA Fiber Laser Engraving Parameters for engraving dark color on aluminum.
These are the best settings for engraving black color over aluminum with a MOPA fiber laser engraving machine BCF or JPT.
Speed
1200 or 1000
Power
45% or 30%
Frequency
250 or 540
Pulse: 10 or 6
HATCH : 1
HATCH type: Bidirectional
ANGLE: 0
LINE SPACE: 0.003 or 0.001
Note: These engraving parameters are for reference, and the results may change deepening on the lens, power laser source brand, metal mixture, ETC.
In our BCF 30W MOPA, these parameters can engrave black with a 10x10cm lens. The result is smooth and does not take coat out.
We have tried with
These parameters have been tried with a fiber laser BCF 30W MOPA with a 10x10cm Opex lens.
Software used
We have used EZcad 2. But these parameters also apply to EZcad 3 and, in general, any laser control card from JCZ.
Variations
Speed, frequency, hatch, and line space, can remain the same, but you may change the power percent if you own a laser with more power or less power.
All this information does not represent the engraving time. The time varies depending on the design or pattern to engrave.
